56
is 192.168.168.230, unless re-configured with the “set ip private…” command (or its HTTP equivalent).
The term of the lease is 10 hours. The factory default is enabled.
⊕
⊕
⊕
⊕
set dhcp
Description
: This command configures the global parameters to be supplied to all requesting DHCP
clients. Note that the DHCP service can also be enabled or disabled from this command.
Example
:
Router> set dhcp
enable DHCP (Yes, Yes/No): yes
configure WINS server (No, Yes/No): yes
enter primary WINS server address (Unspecified): 63.221.98.5
enter secondary WINS server address (Unspecified): 63.221.98.7
enter NetBIOS node type (none, none/b/p/m/h): h
Router>
⊕
⊕
⊕
⊕
set range
Description
: This command sets the bounds for dynamic assignment of IP addresses to both DHCP
clients and dial in users. A dialog ensues wherein the user is asked first to enter the upper bound address,
and then the lower bound address. The default upper bound is the highest address in the configured
private IP subnet. For example, if the configured private IP subnet is 192.168.168.0/255.255.255.0, then
the default upper bound for dynamic assignment is 192.168.168.254. The default lower bound is the high
address less 253, which, in our example, is 192.168.168.1. Any address lower than the lower bound is not
assigned automatically by the router to requesting DHCP clients or dial-in users and may be used for
manual configuration of a LAN device (unless used by another router elsewhere on the LAN).
The administrator may alter these addresses to any address that is valid within the configured private IP
subnet. The upper bound address must be greater than the lower bound address.
Note that dial in users will be assigned addresses in pairs.
The router will check before assignment of any dynamic address to ensure that it is not in use elsewhere
in the network.
If the router’s private IP network is modified, the range values that are in conflict with the new IP
network settings will revert to the above mentioned defaults until manually altered by the administrator.
Example
:
Router> set range
enter upper bound address (192.168.168.254):
enter lower bound address (192.168.168.1):
show dhcp
Description:
This command displays the current status of the Dynamic Host Control Protocol server.
Example
:
