BERTHOLD TECHNOLOGIES NightOWL II LB 983, Operating Manual

Page: 47 / 136

LB 983 NightOWL II Operating Manual Quick Start
43
Adjust the required intensities and click on
to accept the parameters. The control com-
mand will show up in the work flow list.
When all commands are set close the dialog box and save the template by clicking on
.
Please note that while a control sequence is running no measurements can be performed. To
simulate a day/ night cycle several templates with single commands must be defined to allow
measurements inbetween the control steps.

Artificial Daylight (Not available on NightOWL systems)
This command sets the LED illumination panel to a defined intensitiy. The used intensi-
ties are temporarily saved for future use.

Daylight Off (Not available on NightOWL systems)
Turns off the LED Panels. Should be added to a project as Pre-Measurement action to
make sure the artificial daylight is off while measuring.

Daylight On (Not available on NightOWL systems)
Turns on the LED panel using the last used intensities defined through the Artificial
Daylight command. Should be added to a project as Post-Measurement action to make
sure the artificial daylight is turned back on after a measurement.

Illumination
Controls the intensity of the white or infrared LEDs in the dark room for photographic
exposures.