Benelli 2014 BN600, Service Manual

Page: 86 / 243

CHAS
- 85 -
FRONT WHEEL AND BRAKE DISCS
CHECK OF BRAKE DISCS
The procedure below applies to all brake discs.
Check:
• the brake disc
If there is any damage/abrasion, replace.
Measure:
• The deformation of the brake disc.
If out of specifi ed values, correct the deformation or replace the
brake disc.
Brake disc Deformation limit
Front 0.1 mm
Rear 0.15 mm
• Place the bike on a suitable support so that the wheel is
raised.
• Before measuring the bending of the front brake disc, turn
the handlebar right and then left to make sure that the front
wheel stops.
• Remove the brake calliper.
• Keep the gauge at a right angle to the surface of the brake
disc.
• Measure the bending 1.5 mm (0.05 in) under the edge of
the brake disc Fig.A.
Adjust:
• The deformation of the brake disc.
• Remove the brake disc.
• Turn the brake disc, moving it one hole per bolt Fig.B.
• Fit the brake.
NOTE
Tighten the bolts on the brake disc in successive steps and
proceeding in a crossover fashion Fig.C.
T.R.
Tightness torque:
Brake disc Tightness torque
Front 22 N.m
Rear 10 N.m
A
B
1
2
6
3
4
5
C