Benelli 2014 BN600, Service Manual

Page: 199 / 243

- 198 -
ENG
CLIP FITTING
PISTONS
The following procedure applies to all pistons.
During the clip assembly process, install them in the following
order:
1.
Oil scraper clip
2. Clips
3. Top clips
See Fig.A
NOTE
The fi rst and second ring are marked D on the top side and PVD
Fig. A.
Remember to fi t the piston clips so that the letters are facing
upwards.
It is important to lubricate the piston well with engine oil when
fi tting the clips.
The fi rst element to insert in the oil scraper slot is the shim (D).
After placing the shim, insert the side rings (E) Fig. B.
NOTE
The shim and side rings have no top or bottom side, meaning
they can be inserted in any way.
IMPORTANT NOTICE
When installing the shim (D), make sure that the ends are not
overlapping in the slot Fig. C.
D
PVD
A
3
2
1
D
E
E
B
Scorretto
Corretto
C
PISTON FITTING
D
Piston fi tting
Once the piston is assembled (see dedicated paragraph)
To insert the piston inside the cylinders, a special tool* is requi-
red, allowing the seals to be contained
(*)
(*) Piston ring clamp .............................
Code:......................
NOTE
During this stage, lubricate parts with engine oil
The pistons need to be inserted in sequence as they were remo-
ved; do not mix up the order of assembly.
IMPORTANT NOTICE