Benelli 2014 BN600, Service Manual

Page: 225 / 243

- 224 -
ENG
FLYWHEEL REMOVAL
Removal:
1. Remove the caps (3*) and (5*) and the relevant gaskets
from the left casing cover (10*) Fig. A.
2. Remove the 9 fastening screws (1*)
3. Use the specifi c tools (**) to remove the cover (10*)
(**) tool to remove the fl ywheel cover
Code:......................
Check:
1. gasket (11*)
If there is any tearing/traces of wear, replace the gasket.
2. Remove the 3 fastening screws (7)
3. Remove the fastening screw (13*) fastening plate support
(12*)
4. Use the specifi c tools (**) to take out the fl ywheel (10) Fig.
B.
(**) tool to take out fl ywheel
Code:......................
NOTE
The numbers marked (*) are shown in the replacement parts
table in the “Starting” chapter, “Phase sensor installation/
adjustment“ section.
IMPORTANT NOTICE
During the removal of the fl ywheel, remove the fl ywheel-drive
shaft locking key (x) Fig.B
.
5. Take out the double gear (5), shaft (4) and starter gear (6)
Fig. C.
Removal:
Removal of complete freewheel parts (9)
Fig.D
.
1. Remove the 6 fastening screws (11)
Check:
• the roller cage and support.
If there are any anomalies/traces of wear, replace the whole
freewheel.
A
10*
11*
7
13*
12*
1*
B
X
STARTING
C
6
4
5
D
11
(**)