Benelli 2014 BN600, Service Manual

Page: 95 / 243

- 94 -
CHAS
REAR WHEEL AND BRAKE DISC
SPROCKET CHECK AND REPLACEMENT
Check:
• The sprocket
If more than 1/4 of each tooth is worn, replace the sprocket.
If the teeth are bent, replace the sprocket.
1. 1/4 teeth
2. Correct
3. Transmission chain roller
4. Sprocket
Sprocket replacement:
• Once the rear wheel has been removed, take out the spro-
cket, as described in the previous section.
Replace:
• Clean the sprocket fl ange (10) with a clean rag, especially
the surfaces touching the sprocket.
• Insert the 5 fastening nuts (7) and tighten to the following
torque.
T.R.
Torque 45 N*m
NOTE
Tighten the self-locking nuts in several stages, proceeding with a
crossover sequence.
A
1
2
3
4
8
10
11
11 11
11 11
12
12
7
7
7
7
7
B
REAR WHEEL AND BRAKE DISC
BRAKE DISC ASSEMBLY
Brake disc assembly:
• Once the rear wheel has been removed, take out the brake
disc, as described in the previous paragraph.
• Clean the sprocket fl ange with a clean rag, especially the
surfaces touching the disc.
Fit:
• The brake disc (17) and the 6 screws (6) Fig. A
• Use thread locker (medium type) on the end of the thread.
Tighten the fastening screws to the following torque:
T.R.
Torque 10 N*m
NOTE
Tighten the self-locking nuts in several stages, proceeding with
a crossover sequence.
17
6
6
6
A