CHK
ADJ
- 50 -
ENGINE/ENGINE OIL
ENGINE OIL LEVEL CHECK
A
Park:
•
the bike on a level surface.
NOTE:
•
Place the motorbike on suitable stands so that the tyres are
at the same height from ground level.
•
Make sure that the bike is upright.
Start:
•
the engine.
leave it to warm up for a few minutes before switching it off.
IMPORTANT NOTICE:
Do not start the engine if the oil is under the MIN reference of
the rod "B" Fig. A,
Check:
•
the engine oil level
the oil level must be between the minimum level (MIN) and maxi-
mum level (MAX) marks on the dipstick.
If it is below the minimum level mark, top up to the correct level
with the recommended engine oil.
To top up the engine oil:
1. unscrew the oil cap with the engine switched off
2. Pour in enough of a suitable type of oil between the MAX
and MIN levels, Fig. A,
NOTE:
The engine oil level must be checked without screwing in the
dipstick cap
IMPORTANT NOTICE:
Given that engine oil also lubricates the clutch, if it is not the
right type or if it contains additives, it could cause the clutch
to slip. Therefore, we recommend not adding any chemical
additives or using oils of other types than the one listed in the
technical specifi cations for the engine.
Engine oil, whether new or spent, can be dangerous.
If ingested, engine oil may be poisonous to people or pets. In the
event of ingestion, seek medical attention immediately; do not
provoke vomiting to avoid breathing the product into the lungs.
Brief contact with engine oil may irritate the skin.
•
Keep the engine oil out of reach of children and pets.
•
Wear long-sleeved clothing and waterproof gloves every
time you top up the engine oil.
•
Wash off any oil that has come into contact with the skin
with soap and water.
•
Recycle or correctly dispose of spent engine oil.
3. Screw the fi ller cap back in place.
NOTE:
When checking the engine oil level, restart the engine, leave it
to warm up for a few minutes and then switch it off. Wait a few
moments to give the oil enough time to fl ow down.
B
MIN
MAX
Summary of Contents for 2014 BN600
