Benelli 2014 BN600, Service Manual

Page: 235 / 243

COOL
- 234 -
WATER PUMP REMOVAL/FITTING
WATER PUMP
A
Removal:
NOTE
Remove coolant before removing parts.
1. Remove the two pump delivery and return hoses (17*-18*),
taking off the clamps (19*) Fig.A.
2. Remove the 4 fastening screws (9) and take out the pump
Fig.B
3. Take out all of the parts in the order shown in the exploded
drawings and check to ensure each part is intact.
Parts showing signs of wear must be replaced.
IMPORTANT NOTICE
If the ceramic seals (3) are no longer tight, it is possible to see
dripping from the hole shown in Fig.C
NOTE
The numbers marked (*) are shown in the replacement parts
table in the “Cooling circuit” chapter, “radiator removal” section.
Fitting:
1. Once each part has been checked, proceed to assemble
the pump, lubricating the pump shaft (8), bushing (16). and
bearings (6) with engine oil and following the procedure for
removal described above, this time in reverse order.
NOTE
When inserting the pump, make sure that the groove in the wa-
ter pump shaft (8) is facing the direction shown in Fig.B.
2. Apply thread locker to the 4 screws (9) and tighten to the
following torque:
T.R.
Torque 12 N*m
Use Loctite thread locker to secure.
19*
18*
B
C