Benelli 2014 BN600, Service Manual, Page: 55 / 243

CHK
ADJ
- 54 -
FRAME/BRAKE ADJUSTMENT
FRONT BRAKE ADJUSTMENT
Adjust:
• the position of the brake lever Fig. A
(the distance”x” between the accelerator and the brake lever).
NOTE:
Push the brake lever forwards to neutralise the thrust of the
spring and at the same time, adjust the position, turning the ring
nut, "y" clockwise or anticlockwise until the brake lever is where
it should be.
Ring nut Position Distance
Position 1 the distance is further from
the handlebar.
Position 4 The distance is nearer to the
handlebars
WARNING:
If the brake lever is soft or spongy to the touch, this may be a
symptom of air in the brake system. Before using the motorbike,
it is necessary to bleed out the air by emptying out the brake
circuit. Air in the brake circuit will considerably reduce the per-
formance of the system and may even lead to a loss of vehicle
control and possible accidents Therefore, check the system and
if necessary, bleed it.
IMPORTANT NOTICE:
After adjusting the position of the brake lever, make sure that
there is no brake drag of any kind.
A
X
Y