Benelli 2014 BN600, Service Manual

Page: 72 / 243

CHK
ADJ
- 71 -
ELECTRIC SYSTEM/CHECK AND BATTERY CHARGE
BATTERY
Install:
• The battery
• Tighten the 2 screws “C” fastening the battery bracket.
Connect:
• The cables from the battery (to the battery terminals)
IMPORTANT NOTICE:
First connect the positive cable "B" of the battery, then the nega-
tive cable "A" Fig. G.
Check:
• The battery terminals
If dirty, clean with a metal brush.
If there are any loose connections → Reconnect them properly.
G
A
B
C
D
ELECTRICAL SYSTEM/FUSE CHECK
FUSES
The following procedure applies to all fuses.
IMPORTANT NOTICE:
To avoid short circuits, always switch off the main switch by
setting it to "OFF" when checking or replacing fuses.
•
Remove the passenger seat, using the wrench provided
and remove the rider's seat with the release knob (A) Fig, A.
• Open the fuse box "B" Fig. B
Check:
• the fuse
Connect a pocket tester to the fuse and check continuity.
NOTE:
Set the tester selector to “
Ω x 1
”
• If the pocket tester reads “
∞
”, replace the fuse.
Replace:
• Burnt fuses.
- Turn the main switch to "OFF".
- Fit a new fuse with the correct amperage.
- Switch on the switches to make sure that the electrical
circuit is working,
- If the fuse burns out immediately, check the power circuit.
WARNING:
Never use a fuse with amperage other than the one specifi ed.
The use of makeshift techniques or of fuses with the incorrect
amperage may cause irreversible damage to the electrical sys-
tem, causing operating defects in the lights and ignition, or even
cause fi re.
A
A