Begin by removing the factory skid plate from the bike.
Install two threaded “Speed clips” onto the rear mounting
bracket as shown in Fig 1.
Bolt the rear mounting bracket onto the two holes at
the rear edge of the skid plate using two M825T bolts.
Leave these bolts loose to allow easier fitment of the
skid plate.
Insert an M616T bolt through the countersunk hole at
the center of the skid plate. Thread the M6N nut onto
the bolt and tighten it to 9ft/lbs.
Fig1
Fig 2
Fig 3
Step 1
Step 2
Step 3
HTP5-4-88
KTM950/990 SKID PLATE
Thank you for purchasing Happy Trails products. Our products are proudly hand made in Boise
Idaho, USA. If you have any questions or concerns about the installation of this product, please con-
tact us directly at 1-800-444-8770 or e-mail [email protected].
Before you begin, place the bike on a hard level surface where you have room to work. Lay out the
parts included in this kit and compare to the parts list on the final of these instructions. If any parts
or hardware are missing, contact us immediately at the number or email listed above.
