Belden Grass Valley KALEIDO-IP X110, Installation & Service Manual

Page: 82 / 110

82
System Configuration
Shutting Down a Kaleido-IP Multiviewer
Your multiviewer will shut down, and then start again, during which time you can
observe messages associated with the Linux shutdown and boot sequences on the
monitor wall display connected to Head 1. This may take a while.
Once the multiviewer has restarted, the system notifies you.
5 Click OK .
The XAdmin Status and Options page appears.
Shutting Down a Kaleido-IP Multiviewer
To shut down a Kaleido-IP multiviewer
1 Open XAdmin. See Opening XAdmin on page 49.
The XAdmin Status and Options page appears.
2 Click Restart / Shut down in the navigation area on the left side of the page.
Note:
Clicking the “Reset multiviewer” button on the Status and Options
page for a Kaleido-IP is equivalent to the above procedure except that there
is no feedback from XAdmin.
Note:
The Kaleido Software does not support activating a soft shutdown
from the Kaleido-IP frame’s power button. Should you be unable to access
XAdmin, then perform a hard shutdown by pressing and holding the power
button.