Belden Grass Valley KALEIDO-IP X110, Installation & Service Manual

Page: 26 / 110

26
IP Network Setup
Networking Essentials
A client PC must be configured, within the Management Network , to communicate with the
multiviewer (see Multiviewer Model Representation in XEdit and XAdmin , on page 39). You
must also configure any Kaleido-RCP2 units you may have ordered (see System Setup , on
page 67).
The Kaleido-IP is shipped with the following default settings.
Kaleido-IP default IP settings
Kaleido-IP-6 Kaleido-IP-4 Kaleido-IP-2
Management IP address (LAN1) 10.0.3.70 10.0.3.70 10.0.3.70
Network mask 255.255.0.0 255.255.0.0 255.255.0.0
Default gateway 10.0.0.1 10.0.0.1 10.0.0.1
Link mode Auto-negotiate Auto-negotiate Auto-negotiate
Data port 1 IP address (LAN2) 172.30.3.70 172.30.3.70 172.30.3.70
Network mask 255.255.0.0 255.255.0.0 255.255.0.0
Gateway None None None
Link mode Auto-negotiate Auto-negotiate Auto-negotiate
Data port 2 IP address (LAN3) 172.30.3.71 172.30.3.71 —
Network mask 255.255.0.0 255.255.0.0
Gateway None None
Link mode Auto-negotiate Auto-negotiate
Data port 3 IP address (LAN4) 172.30.3.72 172.30.3.72 —
Network mask 255.255.0.0 255.255.0.0
Gateway None None
Link mode Auto-negotiate Auto-negotiate
Data port 4 IP address (LAN5) 172.30.3.73 — —
Network mask 255.255.0.0
Gateway None
Link mode Auto-negotiate
Data port 5 IP address (LAN6) 172.30.3.74 — —
Network mask 255.255.0.0
Gateway None
Link mode Auto-negotiate
Note:
If the management IP address of your Kaleido-IP has been changed
(i.e. it no longer corresponds to the as-shipped configuration), it is still
possible to determine the current
management IP address setting. See
Verifying the Management IP Address and Application Version on page 93.