Belden Grass Valley KALEIDO-IP X110, Installation & Service Manual

Page: 31 / 110

31
Kaleido-IP X310/X110
Installation & Service Manual
16 Click Apply settings .
The multiviewer must be restarted for changes to the network configuration to take
effect. A message appears prompting you to reboot the system immediately.
17 Click OK .
18 If this Kaleido-IP is meant to monitor HLS, RTSP, or RTMP sources, then you must also
configure access to your facilities’ DNS, and proxy servers:
a Click Configure , under DNS and proxy configuration .
The DNS and Proxy Configuration page appears.
b Type the appropriate suffixes for your primary domain, and search domain, and the
IP addresses for the primary, and secondary DNS server.
c Select Enable proxy , and then type the URL of the appropriate proxy auto-config
(PAC) file, if required.
d Click Apply configuration .
A message appears confirming that the changes have been applied.
e Click OK to dismiss the message.
Note:
Settings cannot be applied to a multiviewer system while an
upgrade is in progress. If the multiviewer does not reboot after 10 seconds
or so, try clicking
Apply settings again after a minute or two, until the
multiviewer reboots.