Belden Grass Valley KALEIDO-IP X110, Installation & Service Manual

Page: 30 / 110

30
IP Network Setup
Changing Network Settings in XAdmin
11 Under Date and Time , select the appropriate time zone and format for your location.
12 If this Kaleido-IP is meant to monitor HLS sources, enable NTP synchronization: next to
NTP synchronization , click Enabled , and then type the NTP server’s IP address.
13 Click Save .
The new settings are saved locally.
14 Click OK .
15 The Apply settings button becomes available.
Default gateway If your Management Network is not configured with a gateway,
clear the default gateway IP address, by clicking Remove .
Gateway If data ports and the Management Network are configured within
different subnets, and this Kaleido-IP is meant to monitor HLS, RTSP,
or RTMP sources, add the required gateway addresses, by clicking
Add , and then typing the appropriate gateway address, in the
desired data port sections.
Detected link mode By default, all network adapters are set to auto-negotiate. The
connection speed and duplex mode will be set automatically based
on the corresponding port settings on the associated switch.
Configured link
mode 1000 Mbps full-duplex communication can only be achieved via
auto-negotiation, as required by the IEEE-802.3 standard, section
28D.5. Should your network configuration require specific speed
and duplex mode settings, select the appropriate value from the
Configured link mode list.