BEAMEX MC6-T, Manual, Page: 143 / 172

Cleaning instructions - 143
Figure 140: Overtemperature Protection Test Mode prompt message
Cleaning instructions
Warning:
Disconnect the Mains cord and switch the Mains
switch off before any cleaning actions. Make sure the device has
fully dried up before using it again.
Note: Before using any cleaning or decontamination method,
other than those recommended by Beamex, users should check
with an Authorized Service Center to ensure the proposed
method will not damage the equipment.
1. Inserts and inside of the Temperature Block
• Due to the high operating temperatures of the Temperature Block,
the inserts should be removed after each use and buffed with
a Scotch-Brite
®
pad or emery cloth. Make sure there are no
remaining textile fibers on the insert or the Temperature Block
surface.
• If there is an oxidation on the insert's outer surface it could cause
the inserts to become jammed in the Temperature Block boring.
Avoid this buildup by periodically buffing the inserts clean with an
abrasive pad or fine sandpaper (over 400 grit).
• In case of oil contamination, Temperature Block boring and insert
borings can be cleaned with mild alcohol-based solvent.