8. Final Adjustment and Configuration
OverView D 50" – DOC-3303-5 – installation manual – Revision 10 – September 2006
September 2006
September 2006
September 2006 ________________________________
________________________________
________________________________
________________________________________________________
________________________
________________________
________________________8-41
To change the specified runtime:
•
Move the cursor key to the respective field.
•
Enter the new value by means of the numeric keys of the IR Remote-Control.
in Hot Standby mode. the w arning pops up if the operation time of one of the lamps
exceed the specified value.
In Cold Standby mode: the warning pops up if the operation time of the active lamp
exceeds the specified value.
8.5.13.5
Lamp Top Serial Number / Lamp Bottom Serial Number
This menu allows to change the ser ial number of the cur r ently used lamp, and should be used in conjunction
with the menu
Write Lamp Runtime
as mentioned above.
Figure 8-62
Enter serial number (after lamp exhange)
Use these commands when exchanging lamps within a Display Wall.