8. Final Adjustment and Configuration
OverView D 50" – DOC-3303-5 – installation manual – Revision 10 – September 2006
September 2006
September 2006
September 2006 ________________________________
________________________________
________________________________
________________________________________________________
________________________
________________________
________________________8-28
8.5.6.2
Restore Default Settings
By means of this command, the settings stored in production can be applied again.
Restoring can be done for the projection unit and for the illumination unit.
After the Restore command for the respective device, all adjustments will be lost!
To restore the parameters set in production:
•
Move the cursor key to highlight Restore Default Settings.
•
Press Enter to select.
A selection box shows up to select the device which settings should be restored:
Figure 8-38
select the device to restore its default production settings.
•
Move the cursor key to highlight the desired device.
•
Press Enter to select.
