5. Wall fixation
OverView D 50" – DOC-3303-5 – installation manual – Revision 10 – September 2006
September 2006
September 2006
September 2006 ________________________________
________________________________
________________________________
_________________________________________________________
_________________________
_________________________
_________________________5-5
To complete the A-shape,
•
apply one of the brackets at each side of the short connection profile by means of M10x85. User the spring
washer and nut to fix it.
Figure 5-7
Wall fixation, A-shape version, bracket at the "leg" of the A
•
Fix the brackets at the legs of the "A": insert 4 Kanya nuts into each of the leg profiles and fix the bracket
using screws M6x10 and spring washers. Do only tighten them loosely: by shifting this profile, the angle
between the legs is determined and thus the distance to the wall of the building gets varied.
•
Attach the wall fixation bracket to the end of the profile by means of M10x85. Use the spring washer and
nut to fix it.
•
Position the legs at the wall of the building, and mark the position to drill the holes.
•
Remove the profile from the bracket to be attached to the wall of the building (otherwise drilling and
fixation is very difficult!).
•
Use two dowels FUR 10 to attach the fixation bracket to the wall of the building.
•
Reattach the leg profiles to the brackets now fixed to the wall of the building.
•
Finally really tighten the screws of the brackets at the legs of the "A".
Figure 5-8
wall fixation, A-shape version, fixation to wall of the building