Barco ICMP, Service Manual

Page: 16 / 96

2. General
2.5 ICMP reset
This procedure requires that ICMP version 1.2.4 or later is installed.
ICMP reset possibilities
• The Star button on the local keypad (Not for C- and B-series)
• The ICMP reset button in the GUI of the Communicator.
• The ICMP reset button in the GUI of the Commander.
• The ICMP reset button in the GUI of the Web Commander.
• The ICMP hardware reset button located on the front panel of the ICMP (Not recommended, use only
when all other reset possibilities are exhausted!)
How to reset the ICMP?
1. Click on the ICMP reset button in the GUI of the Web Commander
Or,
Click on the ICMP
reset button in the GUI of the Commander
Note: It can be that the Commander or WEB-Commander is not able to send the reset command.
Or,
click on the ICMP
reset button in the GUI of the Communicator (recommended)
Or,
press the
Star button on the local keypad for a few seconds (Not for C- and B-series)
As a result the projector is safely prepared for the ICMP reboot. All ongoing events on the ICMP (e.g.
ingest) are requested to end. After a few seconds the ICMP is requested to restart. The READY LED
on the front panel of the ICMP starts to blink orange.
In case the ICMP is installed in DP4K-L series projector the lasers are switched off and the projector
remains in the same mode (e.g. Conditioned). The Star button on the local keypad starts blinking
green. After the reset of the ICMP the lasers are switched on again.
Once the READY LED lit continuous green the ICMP is up and running.
2. Did the reset of the ICMP fail?
If yes, perform a hardware reset as follows:
a) switch off the lasers of the projector or switch of the projector lamp.
b) press the ICMP
hardware reset button a few seconds (reference 3 image 2-6) .
Warning: Resetting the ICMP with the hardware reset button may cause damage to the content on the
HDDs. A re-con fi guration of the whole system may be required!
12 R5906594 ICMP 09/11/2016