Baldor VS1SM, Installation & Operating Manual

Page: 40 / 71

7-12 Parameter Descriptions MN761
7.3 Function Group2
Continued
Parameter # Access Parameter Name, Value Range, Description and Preset Value
RW Auto Restart (Range:
0- Off. Motor will not start immediately when fault condition is reset.
1- On. Motor will start acceleration when fault condition is reset)
Sets whether the motor will automatically start after a fault condition is reset
and a Run command is present. After the fault is reset, with drV=1 or 2
and either Forward Run or Reverse Run input is active, the motor will
start immediately.
Preset Value: 0
Reset
Frequency
H21=0 H21=1
Run
command
RW Speed Search (Range:
0- No speed search.
1- Normal search.
2-
After Fault.
3- Normal search, After Fault,
4-
After Fault, After Power Failure,
5- Normal search, After Fault, After Power Failure,
6- After Fault, After Power Failure,
7- Normal search, After Fault, After Power Failure,
8- Power on start.
9- Normal search, After Fault, Power on start.
10- After Fault, Power on start.
11- Normal search, After Fault, Power on start.
12- After Fault, After Power Failure, Power on start.
13- Normal search, After Power Failure, Power on start.
14- After Fault, After Power Failure, Power on start.
15- Normal search, After Fault, After Power Failure, Power on start.
Note: On power start if H20=1)
Note: Normal search done is first even when others are also selected.
Helps prevent faults when attempting to start a running motor.
(After power outage while motor is coasting).
Preset Value: 0
RW Current Level During Speed Search (Range: 80-200%)
Sets the motor current during speed search as a % of H33.
Preset Value:
100
RW P Gain During Speed Search (Range: 0-9999)
Sets the PI Controller Proportional Gain used during Speed Search.
Preset Value:
100