Baldor VS1SM, Installation & Operating Manual

Page: 56 / 71

7-28 Parameter Descriptions MN761
7.4 I/O Group
Continued
Parameter # Access Parameter Name, Value Range, Description and Preset Value
RW Fault Relay Output (Range:
0- None
1- At Low Voltage Trip.
2- All trips other than Low Voltage.
3- All trips.
4- When setting H26 [Number of Auto-Restart Tries]
5- H26 and Low Voltage Trips.
6- H26 and All trips.
7- H26 and All trips.)
Sets the item that will be output by digital and relay outputs.
Preset Value:
2
RW Inverter Station ID (Range: 1-32)
Sets Inverter ID for RS485 Communication.
Preset Value:
1
RW Baud Rate (Range:
0- 1200 bps
1- 2400 bps
2- 4800 bps
3- 9600 bps
4- 19200 bps)
Sets the Baud Rate of RS485 Communication.
Preset Value:
3
RW Drive Mode After Loss of Speed Command (Range:
0- Continue operation at last frequency before command was lost.
1- Coast to stop.
2- Deceleration to stop.)
Sets the action during loss of speed reference command. Speed reference
command by V1 or I terminal or by communication option.
Preset Value:
RW Wait Time after Loss of Speed Command (Range: 0.1-120sec)
Sets the delay after loss of speed reference before I62 is active. If the
Speed Reference command is still lost after this delay, I62 mode occurs.
Preset Value: 1.0