Baldor VS1SM, Installation & Operating Manual

Page: 50 / 71

7-22 Parameter Descriptions MN761
7.4 I/O Group
Continued
Figure 7‐4
P5 (JOG)
Frequency
F20
Run Command (FX)
P1
P5
CM
FX : t1 = 0
JOG t5=4
5 = Speed Select 1 - (see Figure NO TAG)
6 = Speed Select 2 - (see Figure NO TAG)
7 = Speed Select 3 - (see Figure NO TAG)
Used to select Preset Speed 1 - 7 combinations, see P43-P45 and t10-t13, and Figure NO TAG.
8 = Ramp Select1 - (see Figure NO TAG)
9 = Ramp Select2 - (see Figure NO TAG)
10 = Ramp Select3 - (see Figure NO TAG)
Used to define accel/decel ramp combinations for preset speeds, see (t14-t27).
11 = DC brake during Stop: DC voltage will be applied to the motor windings at a level set by DC Brake Start
Voltage (F12) for as long as the digital input is closed. See also F12 and F13 - Starting DC brake
parameters. See Figure 7‐5.
Figure 7‐5
Voltage
Run command
F12
P3
12 = 2nd motor select: When input is present, the drive configures itself for a second set of motor settings
defined in 2nd motor operation parameters (H81 to H90).
13 = Reserved: Reserved
14 = Reserved: Reserved
15 =
Speed increase (UP) : Increases the speed reference to the drive after a run command.
Frequency is saved to parameter F64 on a stop command if F63 = 1 `save up/down frequency'.
16 = Speed decrease (DOWN) : decreases the speed reference to the drive after a run command.
Frequency is saved to parameter F64 on a stop command if F63 = 1 `save up/down frequency'.
17 = 3-W ire operation : Select to define a digital input for 3-Wire control. Inputs defined as forward (FX) and
reverse (RX) are momentary inputs and opening the input defined as 3-Wire operation will stop the drive.
For both 2-Wire and 3-Wire control, P38 - Drive Mode should be set to a 1 for normal operation.
See Figure 7‐6.