Turning
dimensional compensation
on enables the meter to
perform calculations that correct for geometric changes in
the flowcell caused be temperature variations. This may be
helpful in applications where the temperature in or around
the flowcell is known to vary significantly. To select the
dimensional compensation status
, refer to
Figure 48
below
and complete the following steps:
NOTE:
If necessary, refer to
as a
reminder about color code meanings.
1. Refer to
and navigate to
page 3: program
.
2. Use the [
] and [
] keys to highlight
composite
in the list of channels, and press the [
] key twice
to confirm your choice.
3. At the next screen, use the [
] and [
] keys to
highlight the
signal
option. Then, press the [
] key
to confirm your selection or press the [
] key
to return to the previous screen.
4. At the next screen, use the [
] and [
] keys to
highlight the
compensation status
option. Then,
press the [
] key to confirm your selection or press
the [
] key to return to the previous screen.
5. At the next screen, use the [
] and [
] keys to
highlight
on
or
off
and press the [
] key twice to
confirm your status selection or press the [
] key
to cancel the change.
Figure 48: Setting the dimensional compensation status
NOTE:
To select composite, highlight the option and press
key twice to confirm the selection. Once you confirm
your selection you will see the next screen.
NOTE:
Consult Panametrics factory
before changing defaults
Legend
Red
At least user 1 level access required to follow the step.
Green
At least user 3 level access required to follow the step.
Dotted
green
Not all transitional screens are shown (at least user 3 level
access required).
Green
Option only visible to user 3 or above.
36
Summary of Contents for Panametrics Sentinel LCT8
