1. Refer to
and navigate to
page 4: configuration (generic) .
2. Use the [
] and [
] keys to highlight
communication
and
press the [
] key to confirm your choice.
3. At the next screen, use the [
] and [
] keys to highlight
the
modbus
option. Then, press the[
] key to confirm
your selection or press the [
] key to cancel and return
to the previous screen.
4. Set the various parameters as follows:
a. Use the [
] and [
] keys to highlight the
volumetric
option and press the [
] key to confirm your selection.
Then, select the desired option from the list and press
the [
] key twice to confirm the selection or press
the [
] key to cancel the change and return to the
previous screen.
b. Use the [
] and [
] keys to highlight the
total units
option and press the [
] key to confirm your selection.
Then, select the desired option from the list and press
the [
] key twice to confirm the selection or press
the [
] key to cancel the change and return to the
previous screen.
c. Use the [
] and [
] keys to highlight the
std
volumetric
option and press the [
] key to confirm
your selection. Then, select the desired option from
the list and press the [
] key twice to confirm the
selection or press the [
] key to cancel the change
and return to the previous screen.
d. Use the [
] and [
] keys to highlight the
StdTotal units
option and press the [
] key to confirm your selection.
Then, select the desired option from the list and press
the [
] key twice to confirm the selection or press
the [
] key to cancel the change and return to the
previous screen.
IMPORTANT
Modbus communications are now set up and ready to
use. See
Appendix C . Modbus register map on page 117
49
Summary of Contents for Panametrics Sentinel LCT8
