3.5.2 Setting up communication
This section described how to configure
Panalink
and
modbus
communication.
3.5.2.1 Setting up Panalink communications
To set up Panalink communication, refer to
Figure 54
below and complete the steps on the next page.
NOTE:
If necessary, refer to
as a reminder about color code meanings.
Figure 54: Communication - Panalink setup
Use
arrow to highlight “stop bits”
or “data bits” options and press
to
make further selection. (Navigation
pattern similar to parity options.)
Use
or
arrow to highlight the
preferred option and press
twice to confirm selection.
Legend
Green
At least user 3 level access
required to follow the step.
Dotted
green
Not all transitional screens are
shown (at least user 3 level
access required).
Red
Option only visible to user 1 or
above.
Green
Option only visible to user 3
or above.
44
Summary of Contents for Panametrics Sentinel LCT8
