3.5.4 Setting up totalizer error handling
To select the totalize on errors options, refer to
Figure 58
below and proceed as follows:
NOTE:
If necessary, refer to
as a
reminder about color code meanings.
1. Refer to
and navigate to
Page 4: configuration (generic).
2. Use the [
] and [
] keys to highlight
totalize on errors
and press the [
] key to confirm your choice.
3. Use the [
] and [
] keys to highlight the desired
channel
(channels 1 to 8, or composite). Then, press the [
] key
twice to confirm your selection or press the [
] key to
cancel and return to the previous screen.
4. Use the [
] and [
] keys to select either the
yes
or
no
option and press the [
] key twice to confirm your
selection or press the [
] key to cancel and return to the
previous screen.
5. Repeat the previous step as many times as necessary to
configure additional channels.
Figure 58: Selecting the totalize on errors options
Use
or
arrow to highlight the
preferred option and press
twice to confirm selection.
Legend
Green
At least user 3 level access required to follow the step.
Dotted
green
Not all transitional screens are shown (at least user 3 level
access required).
Red
Option only visible to user 1 or above.
Green
Option only visible to user 3 or above.
51
Summary of Contents for Panametrics Sentinel LCT8
