Baileigh TS-1248P, Operator'S Manual

Page: 49 / 104

45
45
9. Lower the blade guard.
10. Start the saw and make the cut. When the
work is cut through, move one or both cut
pieces. If long enough to handle without
danger immediately off to the side, away from
the turning blade.
11. Turn off the motor.
Miter Cross Cutting
This operation is the same as cross cutting, except
the miter gauge is set to an angle other than 0.
After changing the blade angle, verify the alignment
of the guard and splitter and verify that there is
clearance with the saw blade.
Hold the work piece firmly against the miter gauge
and feed the workpiece slowly into the blade to
prevent it from moving during the cut.
Blade Tilt/Bevel Cuts
When the blade tilt stop bolts are properly
adjusted, the blade tilt handwheel allows the
operator to tilt the blade to the left, between 0°
and 45°. This is used most often when cutting
bevels, compound miters or chamfers.
WARNING:
Turn OFF the saw and allow the blade to come to a complete
stop before removing the cut-off piece. Failure to follow this warning could result in
serious personal injury.