Baileigh TS-1248P, Operator'S Manual

Page: 27 / 104

23
23
11. Follow the instructions in Dust collection, power connection and Test Run, and then proceed
to Final Setup to complete the remaining assembly steps.
The remaining tasks required for assembling the saw include: Installing the table insert and
cutting a slot for the blade, checking fence parallelism, installing the blade guard, and calibrating
the blade angle digital readout.
To complete the remaining assembly steps:
1. Disconnect and lockout power to the saw!
2.
Install and cut the table insert, as instructed in “Cutting a Zero Clearance Insert.
3. Verify that the fence is parallel to the blade/miter slot and that this setting did not change
during shipping. The blade was set parallel with the miter slot at the factory. This affects
whether the fence is parallel when mounted to the table.
4. Install the blade guard as instructed in "Installing Blade Guard & Spreader".
5. Calibrate the blade tilt angle digital readout. Each time power is disconnected the digital
readout will also need to be recalibrated.
6.
Install and calibrate the fence digital readout. See “Fence DRO Installation and Calibration”.
DUST COLLECTION
It is recommended that you use a dust collector (not included) when using this machine. The
minimum air flow requirement for this machine are listed below. The machine comes with a 4”
dust port located on the side of the machine.
The dust extraction equipment is to be switched on before commencing machining.
Air current speed is 20m/s for vacuum suction dust emission index.
When air current speed of dust collector device (in accordance with EN12779:2004) is not lower
than 20m/s, ensure machine can be normal exhausted. User must wear dustproof mask.
1. Required air flow: 1500 m3/h.
2. Ensure pressure drop of each dust collector outlet carrying air current speed: 1100Pa.
3. Wind speed of dust collector tube m/s:
Dry Chips: 20m/s,
Wet chips: 28m/s (water content is equal to18%)