Baileigh TS-1248P, Operator'S Manual

Page: 23 / 104

19
19
Extension
Wing 36” Models
1. Inspect the extension wing and main table mating surfaces for burrs or foreign materials. The
mating edges of the wing and the table must be clean, smooth, and flat. Use a wire brush or
file if necessary to clean up the edges. This step will ensure that the wing mounts properly to
the main table.
2. With help of an assistant, install the extension wing hand tight until all hardware is installed
and the wing is both flush and flat with the main table.
3. Place the extension wing between the rails, and
fasten the wing to the front rail with (1) M8-1.25 x 25
flat head screw, 8mm lock washer and M8-1.25 hex
nut (A).
4. Attach the extension wing to the rear rail with (1)
M8-1.25 x 25 cap screw, (2) 8mm lock washers, (1)
8mm flat washer and (1) M8-1.25 hex nut (B).
5. Attach the cast iron wing to the main table with (3)
M10-1.5 x 35 hex bolts and 10mm lock washers (C).
6. Place a straightedge across the extension wing and
main table joint, and adjust the wing to be
perfectly flush with the main table. Hold the wing
in position and completely tighten all 5 bolts.
7. Place a long straightedge across the extension
wings and main table to make sure that the
combined table surface is flat.

If the combined table surface is flat, move to the
next step.

If the outside end of the extension wing tilts down,
use a strip of masking tape along the bottom edge of the main table to shim the extension
wing up.

If the outside end of the extension wing tilts up, use a strip of masking tape along the top
edge of the main table to shim the extension wing down.
Note: After re-installing wings, remove all excess masking tape with a razor blade.
C
B A