Baileigh TS-1248P, Operator'S Manual

Page: 58 / 104

54
54
Adjusting the 45° Bevel Stop
1. Disconnect and lockout power to the saw!
2. Raise the blade as high as it will go, then tilt it towards 45° until it stops and cannot be tilted
any more.
3. Place a 45° square against the table and blade so it contacts the blade evenly from bottom
to top Verify that a blade tooth does not obstruct the placement of the square.

If the blade is 45° to the table, then no adjustment is needed.

If the blade is not 45° to the table, you will need to adjust the 45° stop screw.
1. Tilt the blade to 20°, so there is room for the
stop bolt to move.
2. Loosen the jam nut (A) on the 45° stop bolt.
3. Adjust the stop bolt in or out per how far off the
blade was from 45°. Repeat Step 3 - 6 until the
blade stops at 45°.
4. Tighten the jam nut.
5. Reconnect the power.
6. Recalibrate the digital readout before operating
the table saw.
Table Tilt Handwheel Backlash
The table tilt handwheel should move with no noticeable free play or backlash. Over time the tilt
gears may wear, increasing backlash. The backlash can be eliminated by adjusting the tilt
handwheel gears.
1. Disconnect and lockout power to the saw!
2. Turn the table tilt handwheel one way 2 - 3 turns,
then turn it the other way to feel the backlash.
3. If the handwheel turn 1/16th of a turn or more
before the blade moves, adjust backlash.
4. Open the motor access cover.
Note: The backlash may be set at any
position. Shown tilted to 45° for clarity.
A
A