22
22
On/Off Switch, Fence, Gauge, and Mounts
1. Install the fence tube (A) onto the fence rail using (7) M8-1.25 x 25 bolts. Verify that the gap
between the rail tube and the rail mount is even along the entire length and tighten the bolts.
2. Fasten the switch to the left end of the front rail with (2) M8-1.25 x 12 flange bolts, then insert
the switch disabling lock (B).
3. Install the fence knob (C), and mount the fence on the front rail, to the right of the blade.
4. Install the fence storage brackets onto the back of the cabinet using two M8-1.25 x 12 flange
bolts.
5. Install the handle (D) and 8mm flat washer onto the miter gauge.
6. Slide the miter gauge into the t-slot on the left side of the blade; or store it on the brackets
near the blade angle handwheel.
7. Turn the lock knob that secures the table insert so it is parallel to the inner slot, then remove
the insert and set it aside
8. Raise the arbor all the way up and set the arbor angle to 0°.
9. Unthread the lock knob on the riving knife/blade guard mounting block several turns. Push
the riving knife away from the knob, and then lift the riving knife up to remove it.
Note: The riving knife is installed for shipping purposes. Two pins in the mounting
block insert into matching slots on the riving knife, keeping it secured.
10. Install the saw blade as outlined in Blade Installation.
B
C
D
A
Summary of Contents for TS-1248P
