Configuration Possibilities
AXIS 5570e User’s Manual
165
Disabling Protocols
To further increase security, you must disable protocols that are
considered insecure;
•
FTP (used by AXIS ThinWizard. If FTP is disabled, AXIS ThinWizard can
not function properly.)
•
Telnet
•
Auto-IP
•
DHCP
•
BOOTP
•
Remote Config (used by AXIS NetPilot)
•
SNMP Configuration (also used by AXIS ThinWizard. Note that if SNMP
is disabled, AXIS ThinWizard can not function properly.)
To disable these protocols, go to
Admin | Security Settings | Protocol
Settings | Detailed View
and mark the check boxes. Click
OK
to finish.
Only enabled protocols will be visible from this view!
To enable these protocols, select
Admin | Network Settings | Detailed
View | TCP/IP Network
for FTP, Telnet, Auto-IP, DHCP and BOOTP.
Remote Config is enabled via
Admin | General Settings | RConfig
Support
.
Important:
Checking
SSL/TLS Status
To check SSL/TLS status, open the print server’s Web interface and select
Admin
|
Network Settings
|
Detailed View
|
TCP/IP Network
to see if the
HTTPS Enabled
parameter is set to Yes or No.
To View a Certificate
To view a Certificate, open the print server’s Web interface, select
Admin
|
Security Settings
and click
View
next to the Certificate.
To Delete a Certificate
To delete a Certificate, open the print server’s Web interface, select
Admin
|
Security Settings
and click
Delete
next to the Certificate.
To ensure maximum security, it is highly recommended that you change your Administrator
password after generating a certificate and disabling insecure protocols! This is done from
Admin | General Settings | Change => | General | Root Password.
