K-Series Loom User Manual
Loom Assembly
Install the Rear Cross Member
Page | 21
Finish covering wires
There is a metal track embedded in the wooden horizontal which conceals
the wires going from the motor to the power box. The wires are already
embedded. If the loom is setup for two beams, with two brake motors, a
connection cover is not needed.
1)
Find the cover for the connection between the side frame and the
rear cross member.
Figure 9 - Connection cover
2)
Place the cover over the connection and push it into place.
Figure 10 - Connection Cover on loom
For now allow the wires to hang. They will be plugged in later.