124
To allow audio output from chassis ID 1 headset port and from chassis ID 2 card ID 4 image 3
embedded audio
–
Assign all 8 cards to 1 group
System
Setup Speaker ID
(set chassis ID 2 card ID 4 output audio to chassis ID 1 headset port)
Headphone Parameters
Mute
Off
(chassis ID 1; chassis level so this includes all 4 cards)
Headphone (Local)
Enable
On
(card level so this must be set for chassis ID 2 card ID 4; take
note that only 1 card can be enabled at a time, turning on card ID 4
’s local headphone will cause the
other card
’s local headphone to be turned off automatically)
Headphone (Local)
Source
(card level so this must be set for chassis ID 2 card ID 4; select
“Image 3 embedded audio”)
Headphone (Local)
Channel
Group 1 CH1/CH2
(this is the default setting; card level;
depending on the signal source select another group to monitor if available)
Embedded Audio
Source
(chassis ID 1 card ID 1 to card ID 4 select
“Pass through embedded audio”;
chassis ID 2 card ID 4 select
“Image 3 embedded audio”; card ID 1 to card ID 3 select “Pass through
embedded audio
”)
