3 Connecting Peripheral Instruments
Reflex HC Series
59
3
Connecting Peripheral Instruments
A variety of peripheral instruments can be used with the Reflex
HC series balance, such as an electronic printer, or personal
computer.
This chapter describes how to connect and use peripheral
instruments.
3.1 Electronic
Printer
(1)
Use the default communication settings for the balance
listed below.
Menu
[76]
[77]
[83]
[89]
[92]
[94]
(2)
Disconnect the power to the balance and Electronic
Printer.
(3)
Connect the DATA I/O connector of the balance to the
printer using the cable of the printer.
(4)
First turn ON the power to the balance, then to the
Electronic Printer.
3.2
Personal Computer - RS-232C -
3.2.1
Connecting the Cable
Caution
Signals other than RS-232C are also output by the Reflex HC
series balances through the RS-232C/AUX connector. If these
signal lines are incorrectly connected, damaged may occur to
the personal computer or balance.
Correctly connect an appropriate cable for communication
between the balance and personal computer.
All types of personal computers may not operate normally
when connected with the optional RS-232C cable according to
the diagram.
