03/10 Rev. 5.05-00
USER- / SERVICE MANUAL
Info-Printouts & Parameters
AP 5.4 Gen II – AP 5.6
90
EP Monitor Mode
AP 5.4
AP 5.6
¯
Parameter only appears in production mode.
¯
Activating this parameter may slow down the label rate. Therefore disable
the function after error analysis.
Interpreter data
(Default setting) All received Easy-Plug data, apart from immediate com-
mands, are transmitted.
All data
All received Easy-Plug data, including immediate commands, are trans-
mitted.
Sensor adjust
AP 5.4
AP 5.6
¯
Parameter only appears in production mode.
P
For detailed instructions sensor adjustment, please refer to the service
manual, topic section "Service Electronics", paragraph "Settings".
Sensor test
AP 5.4
AP 5.6
P
The description of the sensor test can be found in the printer service manual,
topic section „Service Electronics“, chapter
Sensor test
.
The values displayed are for checking the sensors (sensor check) and can
by adjusted by service personnel.
Cutter test
AP 5.4
AP 5.6
Makes it possible to test the cutter function without having to set the para-
meter
SYSTEM PARAMETER > Periph. device
to „cutter“.
Press Cut Key
Triggers a cut, if a cutter is installed. Without a cutter nothing will happen.