![background image](http://html1.mh-extra.com/html/avery-dennison/ap5-6/ap5-6_user-and-service-manual_3030321042.webp)
03/10 Rev. 5.05-00
USER- / SERVICE MANUAL
Info-Printouts & Parameters
AP 5.4 Gen II – AP 5.6
42
Stop bits
AP 5.4
AP 5.6
¯
With mounted and connected I/O board only.
P
See parameter
Stop bits
on page 45.
Data synch.
AP 5.4
AP 5.6
¯
With mounted and connected I/O board only.
P
See parameter
Data synch.
on page 46.
Frame error
AP 5.4
AP 5.6
¯
With mounted and connected I/O board only.
P
See parameter
Frame error
on page 46.
Serial Port Mode
AP 5.4
AP 5.6
¯
With mounted and connected I/O board only.
Setting of the serial interface type.
RS232
Sets Com2 to RS 232.
Data synchronisation may be done by hardware (RTS/CTS) or by software
(XON/XOFF). Maximum cable length is 15 m.
RS422
Sets Com2 to RS 422.
RS 422 is a 4 wire point to point connection, suitable for only one device.
Receiver and driver of the printer are always enabled. Data synchronization
is only possible by software (XON/XOFF). Maximum cable length is 1 km with
twisted telecommunication cable.
RS485
Sets Com2 to RS 485.
RS 485 is a 2 or 4 wire bus system for up to 30 devices. The printer´s receiver
is always enabled, the printer´s driver is only enabled, if the printer sends
data to the host. Data synchronization is only possible by software (XON/
XOFF). Maximum cable length is 1 km with twisted telecommunication cable.