03/10 Rev. 5.05-00
USER- / SERVICE MANUAL
Info-Printouts & Parameters
AP 5.4 Gen II – AP 5.6
67
Feed input
AP 5.4
AP 5.6
¯
Only with an I/O board mounted.
Concerns the input signal FEED at the signal interface.
Enabled
(Default setting) Feeding of one label on the falling signal edge. The display
shows „I/O board feed“ during feeding. Requirements are:
y
Offline mode, „stopped mode“ or „pause mode“
y
Online mode and no print job loaded.
Disabled
Signals at the FEED input are ignored.
Pause input
AP 5.4
AP 5.6
¯
Only with an I/O board mounted.
Concerns the input signal PAUSE at the signal interface.
Disabled
Signals at the PAUSE input are ignored.
Pause
A high-to-low transition switches the printer into the “I/O-Board Pause” mode.
The next high-low-transition switches the printer back into the online mode. If
parameter
I/O-Board > Start print mode
is set to „Level high active“ or „Level low
active“, any activating of the PAUSE signal stops the printing after the current
label.
Features:
y
Printer display shows „I/O-Board pause“
y
ERROR is active (only if
I/O Board > Error output
is set to „Printer err+Offl“)
y
If a print job is available: DATA READY becomes inactive (if
I/O Board >
Status output
is set to „Print job ready“)
y
START PRINT signals are suppressed
y
REPRINT requests are processed after switching into online mode.
A "low" signal for 20 ms switches the printer into the pause mode. The pause
mode is the same as the "Online stopped" mode and can be switched to the
“Online” mode by pressing the feed button.
Error output
AP 5.4
AP 5.6
¯
Only with an I/O board mounted.
This parameter defines different events, which activate the output signal
ERROR.
Printer error
ERROR will be activated in all of the following cases:
y
Material end
y
Ribbon end (only if
SYSTEM PARAMETER > Foil mode
= „Thermo transfer“)
y
No punch recognized (only if
PRINT PARAMETERS > Material type
= „punched“)
