AudioCodes Media Pack MP-11x, User Manual

Page: 214 / 650

User's Manual 214 Document #: LTRT-65432
MP-11x & MP-124
3. Configure the Account parameters according to the table below.
4. Click the Apply button to save your changes.
5. To save the changes, see 'Saving Configuration' on page 366 .
6. To perform registration, click the Register button; to unregister, click Unregister . The
registration method for each Trunk Group is according to the setting of the
'Registration Mode' parameter in the Trunk Group Settings page.
Table 18-1: Account Table Parameters Description
Parameter Description
Served Trunk Group
CLI: served-trunk-group
[Account_ ServedTrunkGroup]
Defines the Hunt Group ID that you want to register and/or
authenticate to a destination IP Group (i.e., Serving IP Group).

For Tel-to-IP calls, the Served Hunt Group is the source Hunt
Group from where the call originated.

For IP-to-Tel calls, the Served Hunt Group is the Hunt Group ID
to which the call is sent.
Serving IP Group
[Account_ServingIPGroup]
Defines the destination IP Group ID to where the SIP REGISTER
requests, if enabled, are sent and authentication is done. The actual
destination to where the REGISTER requests are sent is the IP
address configured for the Proxy Set ID that is associated with the IP
Group.
Registration occurs only if:

The 'Registration Mode' parameter is set to 'Per Account' in the
Hunt Group Settings table (see Configuring Hunt Group Settings
on page
237 ).

The 'Register' parameter in this Account table is set to Yes .
In addition, for a SIP call that is identified by both the Served Hunt
Group and Serving IP Group, the username and password for digest
authentication defined in this table is used.
For Tel-to-IP calls, the Serving IP Group is the destination IP Group
defined in the Hunt Group Settings table or Tel to IP Routing (see
Configuring the Tel to IP Routing on page
256 ). For IP-to-Tel calls,
the Serving IP Group is the 'Source IP Group ID' defined in the IP to
Hunt Group Routing Table (see Configuring the IP to Hunt Group
Routing Table on page
263 ).
Note: If no match is found in this table for incoming or outgoing calls,
the username and password defined in the Authentication table (see
Configuring Authentication on page
304 ) or by the global
parameters, UserName and Password (in the Proxy & Registration
page) are used.
Username
[Account_Username]
Defines the digest MD5 Authentication user name.
The valid value is a string of up to 50 characters.
Password
[Account_Password]
Defines the digest MD5 Authentication password.
The valid value is a string of up to 50 characters.
Note: After you click the Apply button, this password is displayed as
an asterisk (*).