AudioCodes Media Pack MP-11x, User Manual

Page: 517 / 650

Version 6.6 517 MP-11x & MP-124
User's Manual 44. Configuration Parameters Reference
Parameter Description
[MaxRADIUSSessions] Defines the number of concurrent calls that can communicate with
the RADIUS server (optional).
The valid range is 0 to 240. The default is 240.
EMS: RADIUS Auth Number of
Retries
[RADIUSRetransmission]
Defines the number of retransmission retries.
The valid range is 1 to 10. The default is 3.
[RadiusTO] Defines the time interval (measured in seconds) that the device
waits for a response before a RADIUS retransmission is issued.
The valid range is 1 to 30. The default is 10.
44.6 SIP Media Realm Parameters
The Media Realm parameters are described in the table below.
Table 44-30: Media Realm Parameters
Parameter Description
Media Realm Table
Web: Media Realm Table
EMS: VoIP > Media >
Media Realm
[CpMediaRealm]
This table parameter defines the Media Realm table. The Media Realm
table allows you to divide a Media-type interface (defined in the Multiple
Interface table) into several realms, where each realm is specified by a
UDP port range.
The format of this parameter is as follows:
[CpMediaRealm]
FORMAT CpMediaRealm_Index = CpMediaRealm_MediaRealmName,
CpMediaRealm_IPv4IF, CpMediaRealm_IPv6IF,
CpMediaRealm_PortRangeStart, CpMediaRealm_MediaSessionLeg,
CpMediaRealm_PortRangeEnd, CpMediaRealm_TransRateRatio,
CpMediaRealm_IsDefault;
[\CpMediaRealm]
For example,
CpMediaRealm 1 = Mrealm1, Voice, , 6600, 20, 6790, , 1;
CpMediaRealm 2 = Mrealm2, Voice, , 6800, 10, 6890; , 0;
Notes:

For this parameter to take effect, a device reset is required.

For a detailed description of this table, see 'Configuring Media
Realms' on page 188.
Quality of Experience Parameters
Web: Server IP
CLI: server-ip
[QOEServerIP]
Defines the IP address of AudioCodes Session Experience Manager
(SEM) server to where the quality experience reports are sent.
Note: For this parameter to take effect, a device reset is required.
Web: Port
[QOEPort]
Defines the port of the SEM server.
The valid value range is 0 to 65534. The default is 5000.