AudioCodes Media Pack MP-11x, User Manual

Page: 620 / 650

User's Manual 620 Document #: LTRT-65432
MP-11x & MP-124
Parameter Description
current over the line, instead of cadence-based 2 second on,
4 second off. For example, when a telephone goes off-hook,
a phone at the other end instantly rings.
If a RING_END event is received before the timeout expires,
the device does not initiate a call and ignores the detected
ring. The device ignores RING_END events detected after
the timeout expires.
The valid value range is 0 to 50 (msec), in steps of 100-msec.
For example, a value of 50 represents 5 sec. The default
value is 0 (i.e., standard ring operation - the FXO interface
sends an INVITE upon receipt of the RING_END event).
Note: The parameter can be configured for a Tel Profile.
[EnablePulseDialDetection] Enables the device to detect pulse (rotary) dialing from
analog equipment (e.g., telephones) connected to the
device's FXS port interfaces.

[0] Disable (default)

[1] Enable
Note: For the parameter to take effect, a device reset is
required.
[EnablePulseDialGeneration] Enables pulse dialing generation to the analog side when
dialing is received from the FXO side.

[0] Disable = (Default) Device generates DTMF signals.

[1] Enable = Generates pulse dialing.
Note: For the parameter to take effect, a device reset is
required.
[PulseDialGenerationBreakTime] Defines the duration of the Break connection (off-hook) for
FXO pulse dial generation.
The valid value range is 20 to 120 (in msec). The default is
60.
Note: For the parameter to take effect, a device reset is
required.
[PulseDialGenerationMakeTime] Defines the duration of the Make connection (on-hook) for
FXO pulse dial generation.
The valid value range is 20 to 120 (in msec). The default is
40.
Note: For the parameter to take effect, a device reset is
required.
[PulseDialGenerationInterDigitTime] Defines the inter-digit duration (time between consecutively
dialed digits) for FXO pulse dial generation.
The valid value range is 300 to 1500 (in msec). The default is
700.
Note: For the parameter to take effect, a device reset is
required.