AudioCodes Media Pack MP-11x, User Manual

Page: 27 / 650

Version 6.6 27 MP-11x & MP-124
User's Manual 2. Assigning the OAMP IP Address
2 Assigning the OAMP IP Address
The device is shipped with a factory default IP address for its operations, administration,
maintenance, and provisioning (OAMP) interface, as shown in the table below:
Table 2-1: Default OAMP IP Address
IP Address Value
IP Address

FXS and FXS / FXO devices: 10.1.10.10

FXO device: 10.1.10.11
Note: FXO interfaces are applicable only to MP-11x series devices.
Subnet Mask 255.255.0.0
Default Gateway IP
Address 0.0.0.0
The default IP address can be used for initially accessing the device, using any of its
management tools (i.e., embedded Web server, EMS, or Telnet). Once accessed, you can
change this default IP address to correspond with your networking scheme in which the
device is deployed. After changing the IP address, you can re-access the device with this
new OAMP IP address and start configuring and managing the device as desired.
This section describes the different methods for changing the device's default IP address to
suit your networking environment:

Embedded command line interface (CLI) - see 'CLI' on page 30

Embedded HTTP/S-based Web server - see 'Web Interface' on page 27

Bootstrap Protocol (BootP) - see BootP/TFTP Server on page 29

FXS telephone voice menu - see FXS Voice Menu Guidance on page 32
2.1 Web Interface
The procedure below describes how to assign an OAMP IP address using the Web
interface.

To assign an OAMP IP address using the Web interface:
1. Disconnect the network cables (if connected) from the device.
2. Connect the Ethernet port located on the rear panel (labeled Ethernet) directly to the
network interface of your computer, using a straight-through Ethernet cable.
Figure 2-1: MP-11x Ethernet Connection to PC for Initial Connectivity