AudioCodes Media Pack MP-11x, User Manual

Page: 301 / 650

Version 6.6 301 MP-11x & MP-124
User's Manual 26. Analog Gateway
26.2 Configuring Metering Tones
The FXS interfaces can generate 12/16 KHz metering pulses toward the Tel side (e.g., for
connection to a pay phone or private meter). Tariff pulse rate is determined according to
the device's Charge Codes table. This capability enables users to define different tariffs
according to the source/destination numbers and the time-of-day. The tariff rate includes
the time interval between the generated pulses and the number of pulses generated on
answer.
Notes:
•
The Metering Tones page is available only for FXS interfaces.
•
Charge Code rules can be assigned to routing rules in the Tel to IP Routing (see
'Configuring Tel to IP Routing' on page
256 ). When a new call is established, the
Tel to IP Routing is searched for the destination IP address. Once a route is
located, the Charge Code (configured for that route) is used to associate the route
with an entry in the Charge Codes table.

To configure Metering tones:
1. Open the Metering Tones page ( Configuration tab > VoIP menu > GW and IP to IP >
Analog Gateway > Metering Tones ).
Figure 26-2: Metering Tones Page
2. Configure the Metering tones parameters as required. For a description of the
parameters appearing on this page, see 'Configuration Parameters Reference' on
page
475 .
3. Click Submit to apply your changes.
4. To save the changes to the flash memory, see 'Saving Configuration' on page 366 .
If you set the 'Generate Metering Tones' parameter to Internal Table , access the Charge
Codes Table page by clicking the Charge Codes Table button. For more information
on configuring the Charge Codes table, see 'Configuring Charge Codes' on page 302 .