AudioCodes Media Pack MP-11x, User Manual

Page: 585 / 650

Version 6.6 585 MP-11x & MP-124
User's Manual 44. Configuration Parameters Reference
Parameter Description
Web/EMS: Use Destination As
Connected Number
[UseDestinationAsConnectedNu
mber]
Enables the device to include the Called Party Number, from
outgoing Tel calls (after number manipulation), in the SIP P-
Asserted-Identity header. The device includes the SIP P-
Asserted-Identity header in 180 Ringing and 200 OK responses
for IP-to-Tel calls.

[0] Disable (default)

[1] Enable
Notes:

For this feature, you must also enable the device to include
the P-Asserted-Identity header in 180/200 OK responses,
by setting the parameter AssertedIDMode to
Add P-
Asserted-Identity .

This parameter is applicable to FXO interfaces.
Web: Caller ID Transport Type
EMS: Transport Type
[CallerIDTransportType]
Determines the device's behavior for Caller ID detection.

[0] Disable = The caller ID signal is not detected - DTMF
digits remain in the voice stream.

[1] Relay = (Currently not applicable.)

[3] Mute = (Default) The caller ID signal is detected from the
Tel side and then erased from the voice stream.
Note: Caller ID detection is applicable only to FXO interfaces.
Reject Anonymous Calls Per Port Table
[RejectAnonymousCallPerPort]
This table parameter determines whether the device rejects
incoming anonymous calls. If enabled, when a device's FXS
interface receives an anonymous call, it rejects the call and
responds with a SIP 433 (Anonymity Disallowed) response.
The format of this parameter is as follows:
[RejectAnonymousCallPerPort]
FORMAT RejectAnonymousCallPerPort_Index =
RejectAnonymousCallPerPort_Enable;
[\RejectAnonymousCallPerPort]
Where,

Enable = accept [0] (default) or reject [1] incoming
anonymous calls.
For example:
RejectAnonymousCallPerPort 0 = 0;
RejectAnonymousCallPerPort 1 = 1;
Note: This parameter is applicable only to FXS interfaces.