Associated Research HYPOTULTRA III 7620, Operation And Service Manual, Page: 51 / 148

43
Calibration Alert Screen
The Calibration Alert Warning screen appears as follows:
With all security settings set to off.
C A L I B R A T I O N A L E R T
M o d e l 7 6 5 0 i s d u e f o r c a l i b r a t i o n o n
1 0 / 1 6 / 0 5 . C o n t a c t A s s o c i a t e d R e s e a r c h
t o a r r a n g e f o r c a l i b r a t i o n .
S h o w t h i s s c r e e n a g a i n ? Y e s
C a l l 1 - 8 0 0 - 8 5 8 - 8 3 7 8
O K
With security set to ON and password enabled.
M o d e l 7 6 5 0 i s d u e f o r c a l i b r a t i o n o n
1 0 / 1 6 / 0 5 . C o n t a c t A s s o c i a t e d R e s e a r c h
t o a r r a n g e f o r c a l i b r a t i o n .
S h o w t h i s Y e s
C a l l 1 - 8 0 0 - 8 5 8 - 8 3 7 8
O K
At the Calibration Alert Warning screen, there are two options, “Show screen again?”, Yes or
No”. “Show screen again?” is asking if you would like to continue seeing the Calibration Alert
Warning screen every time you power up the instrument. The question must be answered by
toggling between the word “Yes “and “No” using its corresponding softkey and then pressing
the OK softkey. You may turn this screen “OFF” by toggling to the word “No” using the soft
key next to this parameter and pressing the “OK” soft key. Selecting the “Show this screen
again” parameter “No” will disable the Calibration Alert function. You may leave this screen
“ON” by toggling to the word “Yes” using the soft key next to this parameter and then pressing
the “OK” soft key. Selecting the “Show this screen again” parameter “Yes” will exit the
Calibration Alert Warning screen and go to the Perform Test screen without disabling the
Calibration Alert function.
If the security is enabled without a password (password set to 0), you will not see the question
“Show screen again” or the “Yes/No” soft key. The only option available is to press the “OK”
soft key. This guarantees that while the security is enabled that the Calibration alert once
tripped cannot be disabled with out going to the Systems menu and turning it off.
If the security is enabled with a password, the Password pop-up screen will appear over the
Calibration alert screen. The instrument while in this state will be virtually unusable until the
password is entered. Once the password is entered, the security at the Calibration Alert screen
will be bypassed and the “Show screen again?”, Yes or No, options will be available as
described previously.
P a s s w o r d
XXXXXX