M
ODULO
9
–
C
ONTROLLI
PRIMA
DELLA
MESSA
IN
STRADA
2007-1.0 – ITA Modulo 9 / Pag.
2
Before starting driving
Warning: Please, follow carefully the next Instructions before starting driving the ARx-540:
4.
Remote Control Check
Once completed installing the motor bike, the remote control with its servo check the proper
functioning: positioning the stick of the steering on the right side, the wheel should steer to
the left. Move the reverse steering channel if it doesn’t happen.
5.
Mechanic Flywheel test
Position the motor bike on the stand controlling that the rear wheel doesn’t touch the
ground. Now, keeping the bike with one hand on the saddle (
WARNIG: AVOID ABSOLUTELY
TO PUT THE HAND NEAR THE REAR WHEEL AND/OR THE CHAIN TO AVOID INJURIES!!!)
accelerate as much as possible for some seconds, controlling the correct sense of direction.
Then break completely and verify if the flywheel is continuing to rotate in the rear wheel,
noticing some vibrations.
6.
Electric Flywheel test
Position the bike on its stand after installing the main battery. Turn on the Gyro switch and
chech the starting of the gyro.If this doesn’t happen, after checking all the electric
connections, use one of the following triks:
-
once turned the switch on lift the front wheel slowly to help the motor to start.
-
Right after the flywheel turns off turn off the switch and than immediately after turn it
on. Repeat this till when the gyro gets enough speed and goes on by itself.
BUON DIVERTIMENTO DA PARTE DI AR RACING!