INSTRUCTIONS
S
KATEBOARD
R
ACER
S
ET
S
KATEBOARD
R
ACER
S
ET
S
KATEBOARD
R
ACER
S
ET
WWW.REVELL.COM
Contents
1.
(1) Precut Wood Block
2.
(4) Axles
3.
(4) Wheels
4.
(1) Stick-On Chassis Weight
5.
(2) Decal Sheets
6.
(1 each) Sandpaper 120 & 220 Grit
Read the entire instruction
sheet before beginning
assembly.
Adult supervision
is required!
Assembly Instructions
1
1.
Sand the body
using coarse (120
grit) sandpaper
fi rst, followed by
medium (220 grit)
paper. Optional:
to smooth out the
racer, use fi ner
paper.
2.
Test fi t the
wheels and axles
for proper fi t.
Adjust as needed.
Set them aside for
later use.
Detail the Body
2
1.
Clean all dust
from the racer.
Apply a thin coat of
paint
1
as evenly as
possible. When dry,
use fi ne sandpaper
to lightly scuff
the paint. Apply
additional coats as
needed.
Do
not
scuff the fi nal coat.
2.
Test fi t the
decals with the
backing still on.
Once you are sure
of their placement,
peel off the
backing and apply.
3.
Use a foam
brush
1
to apply an
even layer of clear
coat.
1
Extra layers
can be applied if
needed.
Installing the Wheels and Axles
3
1.
Place a wheel on
each of the axles,
and press them
into the axle slots
on the bottom of
the racer.
2.
Space each
wheel to have
a small gap.
Place the wheel
adjustment tool
2
between the racer
and the wheel.
Move the axle and
wheel until the
tool fi ts snugly
between the inside of the wheel and the outside of the racer.
3.
Place the kit
on a smooth, fl at
surface. Place a
wheel adjustment
tool
2
with the
camber check
section against the
face of the wheel.
Adjust each axle to
make the wheels
parallel to the edge of the adjustment tool.
WARNING:
CHOKING HAZARD —
Small parts.
Not for children under 3 years of age.
