Artesyn Centellis 2100 Shelf Release 3.0, Installation And Use Manual

Page: 177 / 190

Software
Centellis 2100 Shelf Release 3.0 Installation and Use (6806800T37D)
177
fcu -t<ipmb_addr> -uvf /root/C2100_Fantray-upgrade-1_04_145.hex
The ipmb_addr parameter is c8 for the rear fan tray, or ca for the front fan tray. For example:
fcu -t 0xc8 -uvf /root/ root/C2100_Fantray-upgrade-1_04_145.hex
fcu -t 0xca -uvf /root/ root/C2100_Fantray-upgrade-1_04_145.hex
Centellis 2100 10G Telco Alarm User Card IPMI Firmware:
The fcu utility can be used to upgrade the Centellis 2100 10G Telco Alarm User Card with the
following syntax:
fcu -t<ipmb_addr> -uvf /root/C2100_10G_ALARM_USERCARD-upgrade-
1_04_003.hex
The ipmb_addr parameter is d0 for the upper User Card, or d2 for the lower User Card. For
example:
fcu -t 0xd0 -uvf /root/C2100_10G_ALARM_USERCARD-upgrade-
1_04_003.hex
fcu -t 0xd2 -uvf /root/C2100_10G_ALARM_USERCARD-upgrade-
1_04_003.hex
11.1.2.2 hubcfg Utility
The "hubcfg" utility can also be called from the command line. If no parameters are specified
the user enters an interactive mode and receives the prompt "
MDK.0>
". If the parameters "
-f
<full_path_filename>
" is specified then "hubcfg" will execute the commands found in
the file and then exit.
Interactive commands supported

portmode <port_list> - to display the status of the links
Example:
MDK.0> portmode 0-4
Port 0: 100fd, auto-neg, link up
Port 1: 10fd, auto-neg, link up
Port 2: 1000fd, auto-neg, link up