Artesyn Centellis 2100 Shelf Release 3.0, Installation And Use Manual

Page: 145 / 190

Network Management and System Access
Centellis 2100 Shelf Release 3.0 Installation and Use (6806800T37D)
145
8.2.2 Shelf Geographical Address
The shelf geographical address (SGA) is used to calculate the shelf manager IP addresses on the
out-of-band interface (see
Out-of-Band Interface on page 148 ). Therefore, changing the shelf
geographical address also changes the shelf manager IP address.
8.2.2.1 Setting the Shelf Geographical Address
Set the shelf geographical address during the system installation via a network connection.
Setting the Shelf Geographical Address
To set the shelf geographical address, proceed as follows:
1. Log in to the active shelf manager.
2. Change the shelf geographical address:
# hpishaddr -b "<new shelf geographical address>"
Where
<new shelf geographical address>
must be two hexadecimal
digits with number leading "0" and here "x" is shelf geographical address.
Example: Changing the shelf geographical address to 7:
# hpishaddr -b "07"
3. Reboot the shelf.
You can reboot the shelf mangers via a software reboot without powering OFF and
ON the entire shelf.
The ATCA-MF106 boards will come up with changed IP addresses.
8.2.2.2 Shelf Manager Replacement Scenarios
This subsection describes different scenarios of replacing the shelf manager and determining
the shelf FRU information.
The change of shelf address, shelf IP address and FRU activation order takes effect after a
reboot of the system.